Plywood and particle boards are such popular construction and DIY materials. They are sturdy enough for their purposes and are also versatile and sustainable. However, theres a downside, in that their edges tend to be craggy and serrated even after the finishes are applied. This can be easily remedied with biesse edgebander in Utah.
Edge banding is very popular and pervasive. Even when one has no idea what it is about, then its still likely that they''ve seen the process or application itself. An edge band is a narrow strip of material that outlines the fringes of wood furniture during finish carpentry. This makes the whole fixture more durable as well as stable and solid.
The band is adjustable in terms of its make. A whole range of materials from wood and wood veneer, PVA, acrylic, the organic compound melamine, and the thermoplastic polymer ABS can be used to make it. The outcome is that it covers the exposed sides of the boards and plywood, making it more enduring and aesthetically pleasing.
Traditionally, applying edge banding used to be such a pain in the rear. It required a considerable repository of carpentry tools and manual elbow grease. Modernly, however, there already are wide ranges of factory manufacturing steps that are applicable, such as the use of hot melt adhesive. These methods are no doubt easier when compared to the first.
After the construction or assembly has been done, then all you need to do is to proceed with the banding. However, if you dont take the pains to make sure that everything is as optimized as possible, you might find yourself grappling with a loss in profits. Therefore, instead of finding some solutions, you end up being on the losing end where money, time, and effort are concerned.
Therefore, ensure that everything is user friendly. If not, there will be in congruence in terms of effort and returns. Your production and solutions must be flexible and customized. If not, then you stand to be on the receiving end of customer dissatisfaction, and everything will be all for naught. Ideally, the machine and toolset will need to be space saving. The setup must be quick and the changeover should be rapid.
Natural wood will always be a preferred material for building and furniture making. Therefore, theres a need to pin down its imperfections and issues, especially where mass production is concerned. Because it naturally expands and contracts with the vagaries of its environment, outcomes like joint failure may result. Particle boards and plywood are susceptible to this to a certain extent but are more touch than natural wood.
There are all the reasons in the world to go through with edge banding. The first is that it provides a cover up for plywood and boards. No matter how great and amenable these materials are, there's no denying the fact that they are cheap and do not endear themselves to the so called sophisticated customers. When the exposed edges are skillfully covered up, then it gives the seeming expression of solid natural wood.
Also, seeing the edgings veer away from the appearance of the facade and surface is quite an eyesore. When you cover that up, then it really vamps up the visuals. Not to mention that the chips and splintering fragments can be injurious. Therefore, its better to subdue and tame it all with an edge band.